Kit for the conversion from an ACF2000V made of PVC (grey base) with injector to a model with wooden air stone module.
For the acrylic glass (PMMA) models, this retrofit kit is required.
For the conversion, the injector including the inlet pump is uninstalled. The new piping including the gassing module is screwed onto the skimmer inlet. A smaller water inlet pump must be installed or the energy-saving pump used must be throttled further. The gas supply module requires a suitable air pump: use a suitable air check valve or install a safety loop (at least 60 cm in height measured from air valve) so that no water can run back into the air pump in the event of a failure.
The conversion kit consists of:
- gas supply module with air wood size 3
- connector for UP3000 (silicone hose with cable ties)
- connection piece to 10 mm PE hose for air connection with hose clamp for adjusting the air volume
You need following parts:
Skimmer ACF2000V-060
Water pump with 1300 l/h at 1.0 m pressure
air pump with 700 l/h at 230 mbar