Conversion kit for skimmer ACF3000V-060 PMMA (acrylic glass version) to air wood operation - an air pump is also required.
For the conversion, the injector together with the feed pump or the needle wheel pump with feed bend must be uninstalled. At the now free inlet of the skimmer the gassing module is screwed with the long pipe end. The position of the gassing module can be changed at any time by loosening the union slightly. At the inlet of the gassing module either the universal connector with the red valve can be screwed on or the adapter for the UP5000e pump.
The UP5000e adapter is screwed directly onto the pump. - A silicone hose should be selected for the connection to the supply pump at the red valve. Secure the hose connections with cable ties.
Make sure that a pump with the appropriate power is used.
The gassing module also requires a suitable air pump: use a suitable air check valve or install a safety loop (at least 60 cm in height measured from the air valve) so that no water can run back into the air pump if it should fail or be switched off.
For the old models made of PVC (gray base) this retrofit kit is needed.