Phosphate filter PO4-X-50: for 110 to 325 litres

The feed water from the aquarium is pumped into the system by means of a bypass of the main pump or an additional feed pump. The water flows from bottom to top through the filter. The phosphate is removed from the water and safely bound by the adsorber.

If the phosphate concentration falls below 0.05 mg/l PO4, the flow should be reduced. If it rises above 0.2 mg/l, please increase the flow rate. The maximum flow rate should not be exceeded, because otherwise the material accumulates on the upper sponge.

If the phosphate concentration in the aquarium rises again, the material must be replaced. - The material should be used in the filter without flushing. 

• Reactor with 5 mm screen and filter sponge for intake the filter material
• cap with hybrid closing, filter sponge and screen
• internal, removable screen for very fine filter materials in fluidized bed or vertical flow mode
• 8 mm PA fittings with nozzles (other connectors are available: ellbow fittings, push-fit fittings, PVC fittings, Eheim connectors; ozone resistant connectors are available, too)
• central tube with deflector for vertical-flow-operation (VFF = Vertical Flow Filter)
• silicone feed for a stable stand on smooth surfaces
• international mounting and operation manual
• high-performance phosphate adsorber PO4-X globules

diameter: 50 mm
total height: __ cm   please select the desired length (other heights on request: choose the product "surcharge special lenghts")
useable volume: approx. __ liters  please select the desired length
foot print size: 150 x 100 mm
bottom strainer: 2 mm, demountable
cap strainer: about d11 mm with filter sponge; others are available
hybrid closure: magnetic (without screws) for low pressure operation; screws for higher pressure are scope of delivery
Main tube: rotatable in 90° steps
materials: PMMA (acrylic glass), NBR rubber, silicone rubber, PA
weight: __ kg  please select the desired length
connectors: 1/4" BSP female threads with 8 mm PA fittings
connector for drain: a 1/4" BSP drain valve is mountable

Tutorial (modus: fluidized bed filter)

Tutorial (function: +Globuli in vertical flow filter)

Leaflet

Instruction manual MF2-50

Check List

Bracket for hang-on installation: mf2-050-halter

Wall bracket: mf2-clip-set

Cap (cap with magnets, screws): MF2-50cap

Filter sponge: 313-15

Screen for filter sponge: MF2-50-sieb

Bottom screen with 3 mm holes: MF2-50-d3

Bottom screen with 5 mm holes: MF2-50-d5

Insert for reverse vertical flow filter: MF2-050-RVFF

Insert for reverse moving bed + trickling filter: MF2-050-trick

Central tube with deflector: MF2-050-ZR16

1/4" closure for auxiliary connector: cap-1/4

O-Ring for cap: 054x4N

O-Ring between basis and main tube: 18x3.5N

PA screws for cap screens: SK-M06x30-PA

PA screw for fixing the main tube to the base: SK-M04x25-PA

PA wing screws: FK-M06-20PA

Silicone feet: FR2000.19

Stainless steel stick for pulling out of the screens: MF2-stab

Connector with nozzle: PA R1/4"-8 mm

This filter does not belong in the hands of small children - danger of swallowing small parts!

 The filter is equipped with strong magnets - be careful with handling (risk of crushing). People with cardiac pacemakers should be particularly careful with the filter.