Phosphate filter PO4-X-150: for 1200-2900 l aquariums

The feed water from the aquarium is pumped into the system by means of a bypass of the main pump or an additional feed pump. The water flows from bottom to top through the filter. The phosphate is removed from the water and safely bound by the adsorber.

If the phosphate concentration falls below 0.05 mg/l PO4, the flow should be reduced. If it rises above 0.2 mg/l, please increase the flow rate. The maximum flow rate should not be exceeded, because otherwise the material accumulates on the upper sponge.

If the phosphate concentration in the aquarium rises again, the material must be replaced. - The material should be used in the filter without flushing. 

• Filter with lid and additional connections
• Moving bed screen with deflector plate
• Filter screen 15 mm with filter sponge and screen with spacer
• Inlet ball valve with check valve
• Outlet union
• Drain ball valve for 6/4 hoses
• Nozzle d25 for inlet and outlet
• Silicone feet
• 1 filling High-End phosphate adsorber Phosphate-X-Globuli

Diameter: 150 mm
Reactor height: __ cm select the desired length
Useful volume: approx. __ litres select the desired length
maximum aquarium size: approx. __ litres  select the desired length
maximum flow: 200...280 litres per hour
lower sieve: moving bed screen
upper sieve: 15 mm plus filter sponge
Footprint: 310 x 220 mm
Closure: PA-wing screws
Materials: high quality PMMA (acrylic glass), NBR, silicone, PA
Weight: __ kg select the desired length
Inlet: PVC ball valve d25 + check valve; a d25 hose nozzle is included in the delivery.
Outlet: ABS screw fitting d25; a d25 hose connector is included in the delivery
Drain connection: G1/4" drain valve for 6/4 hose
Lid connection: one G1/2" connection is available
Electrode connection in cover: prepared for electrode set

Leaflet

Instruction manual PMMA filter 150 INT

Instruction manual FBF fluidized bed filter INT

Instruction manual phosphate filter INT

Upper screen

Upper screen with spacer

Filter sponge

Lower insert with deflector plate

Spare lid

Main tube

O-ring for main flange 160 x 4

O-ring cord for main flange, outer groove d4 (a length of 660 mm is required)

O-ring for screen flange bottom 132 x 3

O-ring for screen flange top 100 x 4

PA Wing screw M8x25

PA washer d8,5

PA slit screw for bottom main flange, M8x25

PA slit screw for sieves, M6 x 20

Drain valve / aeration valve G1/4"-6

1/2" closure for auxiliary connector: cap-1/2

PU self-adhesive foot

Spare ball valve d25 (inlet)

Spare union (outlet)

connector for PVC ball valve d25

connector for PVC union d25

 This filter does not belong in the hands of small children - danger of swallowing small parts! 

Please note the operating weight if you want to hang the filter on an aquarium, filter tank or wall.